Allen's Law Enforcement Safety Products

Installation Instructions Installation Diagram

STEP #1 Remove lower handguard.

STEP #2 Insert the round threaded adapter thru hole in lower handguard. Align and install 5/16” sling swivel stud.

STEP #3 Start 10-32 x 1/4" Allen Screw into the top of the mounting column with supplied Allen Wrench.

STEP #4 Place the mounting column over the front sling swivel stud. Align the thru holes; then install and center the retaining pin. Tighten the Allen Screw. Install new 1/2” threaded sling swivel stud and tighten.

STEP #5 Remove backing from Neoprene Pad. Align and affix to bipod mounting bracket.

STEP #6 Align and install Bipod over the mounting column with legs parallel to the barrel and pointing toward muzzle. (Depress “Snap-N-Lock” button and rotate legs 180°)

STEP #7 Place nylon washer over mounting column. Install mounting nut onto column and hand tighten plus 1/4 turn maximum. Failure to follow this procedure could result in damage to stock. Do Not Over tighten!

STEP #8 Your Advanced Technology, Inc. Bipod is now in place and ready to use.

STEP #9 To adjust legs forward, down, or rearward simply depress the “Snap-n-Lock” button and rotate leg to the desired location. Then release the button.

STEP #10 To adjust height (inner leg) twist knurled thumbscrew 1/4 turn and legs will freely drop. Re tighten thumbscrew. To retract legs simply invert rifle and repeat process.

SKS Featherweight Non-Swivel Bayonet Lug Mount Bipod
Part#BIP-0700 $34.50
***MAKE SURE YOUR FIREARM IS UNLOADED BEFORE STARTING***
Step #1 Remove the bayonet from bayonet lug.

Step #2 Adjust legs into the “Down Position”. Depress the “snap-n-lock” button and rotate leg 90°, then release button.

Step #3 Place the open end of the clamp onto the rear of the bayonet lug.

Step #4 Orient the locking block over the front of the bayonet lug. Use the supplied #10x1” phillips screw to secure the locking block. Do Not Over tighten!

Step #5 Your Advanced Technology, Inc. Bipod is now in place and ready to use.

Step #6 To adjust legs down, or rearward simply depress the “Snap-n-Lock” button and rotate leg to the desired location. Then release the button.

Step #7 To adjust height (inner leg) twist knurled thumbscrew 1/4 turn and legs will freely drop. Re tighten thumbscrew. To retract legs simply invert rifle and repeat process.

Note: Do Not Fire SKS Rifle With Legs Folded Forward

STUD Mount Featherweight Bipod
#BIP0900 Swivel $39.50
#BIP0800 Non-Swivel $34.25

Simple to install without gunsmithing using existing swivel stud. Weighs 8oz. One-second extend/retract.
Unique "Snap-N-Lock" button to fold forward, down or rearward. No gunsmithing to install. All hardware included.

Two models: Swivel 60° or non-swivel. Allows use of a sling. Non-slip rubber feet. Proudly made in the USA. Unconditional lifetime warranty. Protective pad included for wood stocks.